Step three Design. Lay out and measuring is the key The little round balls at the end of the track were a challenge but I got it done.
Step 4 Cutting. I had to put this on hold.. My machine would only cut smallish things at first because of the track and the wiring and the other gremlins in the works. So it is off to killing gremlins I go.
Step 5 Cutting. Gremlins Dead I got the board strapped down to the table now and I am ready to start cutting.. This beast is going to take 4 bit changes and has 19 steps. I hope I got every thing right..
No comments:
Post a Comment